How to Install a Peep Sight Without a Bow Press
Installing a peep sight on a bow can be a daunting task, especially if you don’t have access to a bow press. However, with a few simple tools and some patience, you can successfully install a peep sight without the need for a bow press. In this article, we will guide you through the process step by step.
Materials Needed:
Before you begin, gather the following materials:
– Peep sight
– Bow string loop
– Peep sight tool or a piece of stiff wire
– String wax or lubricant
– Soft cloth or rag
Step 1: Prepare the Bow String
Start by removing the bowstring from the bow. Ensure that the bowstring is clean and free of any debris. If necessary, apply string wax or lubricant to the string to prevent it from fraying during the installation process.
Step 2: Position the Peep Sight
Hold the peep sight in place where you want it to be installed. This is typically about 1 to 2 inches above the nock point. Make sure the peep sight is parallel to the bowstring and centered between the limbs.
Step 3: Mark the String
Using a piece of stiff wire or a peep sight tool, gently press the string against the peep sight. This will leave an indentation in the string, indicating where the sight needs to be cut. Make sure the indentation is in the correct position before proceeding.
Step 4: Cut the String
Using a sharp knife or a pair of scissors, carefully cut the string at the marked point. Be sure to make a clean, straight cut to avoid any unnecessary fraying.
Step 5: Install the Peep Sight
Slide the peep sight onto the string, ensuring that it is positioned in the indentation you made earlier. Hold the sight in place with one hand while you work the string through the peep sight with the other hand.
Step 6: Secure the Peep Sight
Once the string is through the peep sight, use your fingers to pull the string tight. Make sure the peep sight is securely in place and that there are no gaps between the sight and the string.
Step 7: Adjust the Peep Sight
Adjust the peep sight until it is centered and aligned with the bowstring. Make sure the sight is parallel to the string and that it is at the desired height above the nock point.
Step 8: Reassemble the Bow
Once you are satisfied with the peep sight’s position, reassemble the bow by threading the string through the limbs and securing it with the bowstring loop. Tighten the limbs and check the bow’s draw weight and arrow rest position to ensure everything is functioning correctly.
Conclusion
Installing a peep sight without a bow press is possible with a bit of patience and the right tools. By following these steps, you can successfully install a peep sight and improve your accuracy on the target. Happy shooting!
