How to Install the ARRMA Vorteks Front Bumper on the Typhon 3s RC Truck- A Step-by-Step Guide

How to Install Arrma Vorteks Front Bumper on Typhon 3s

Installing a new front bumper on your Arrma Typhon 3s can significantly enhance its appearance and protection. The Arrma Vorteks front bumper is a popular choice among RC enthusiasts for its sleek design and durability. In this article, we will guide you through the process of installing the Arrma Vorteks front bumper on your Typhon 3s, ensuring a hassle-free experience.

Materials Needed:

Before you begin the installation, gather the following materials:

– Arrma Vorteks front bumper
– Typhon 3s RC car
– Screwdriver
– Socket set (if needed)
– Optional: Locking nuts and washers

Step 1: Prepare the Typhon 3s

Start by parking your Typhon 3s on a flat and stable surface. Make sure the vehicle is turned off and disconnected from the controller. This will prevent any accidental movements during the installation process.

Step 2: Remove the Old Bumper

Locate the screws or bolts that hold the old front bumper in place. Depending on your Typhon 3s model, there may be several screws or bolts to remove. Use a screwdriver or socket set to carefully remove them. Set the screws and bolts aside for later use.

Step 3: Remove the Front Bumper Mounts

The front bumper mounts are typically held in place by screws or bolts. Remove these mounts by unscrewing them from the vehicle’s frame. Again, set the screws and bolts aside for later use.

Step 4: Install the New Bumper

Position the Arrma Vorteks front bumper on the Typhon 3s frame. Make sure it is aligned correctly with the mounting points. Once the bumper is in place, secure it by inserting the screws or bolts that you removed earlier. If needed, use a socket set to tighten the bolts.

Step 5: Install the Front Bumper Mounts

Now, reattach the front bumper mounts to the vehicle’s frame. Thread the screws or bolts through the mounts and into the frame. Tighten them securely, ensuring that the mounts are firmly in place.

Step 6: Check the Installation

Double-check the installation of the Arrma Vorteks front bumper. Make sure that the bumper is securely mounted and that there are no loose screws or bolts. Test the vehicle by gently pushing it forward and backward to ensure that the new bumper is functioning correctly.

Step 7: Optional: Add Locking Nuts and Washers

For added security, you can install locking nuts and washers on the screws and bolts. This will prevent them from loosening during use. Simply thread the locking nuts onto the screws and bolts, and tighten them securely.

Conclusion

Congratulations! You have successfully installed the Arrma Vorteks front bumper on your Typhon 3s. This new bumper will not only enhance the appearance of your RC car but also provide added protection for the front end. Enjoy your upgraded Typhon 3s and hit the track with confidence!