How to Safely Remove the Ignition Switch from a 1970 Honda CL175- A Step-by-Step Guide

How to Remove Ignition Switch from 1970 Honda CL175

The 1970 Honda CL175 is a classic motorcycle that has captured the hearts of many enthusiasts. One of the most common maintenance tasks for these bikes is replacing or repairing the ignition switch. Removing the ignition switch from a 1970 Honda CL175 may seem like a daunting task, but with the right steps and tools, it can be done efficiently. In this article, we will guide you through the process of how to remove the ignition switch from your 1970 Honda CL175.

First and foremost, ensure that your motorcycle is turned off and the engine is cool before beginning this task. Safety should always be your top priority when working on your motorcycle. Here is a step-by-step guide on how to remove the ignition switch from your 1970 Honda CL175:

1. Gather the necessary tools: You will need a socket set, a wrench, and possibly a flathead screwdriver. It is also recommended to have a torque wrench on hand to ensure that all bolts are tightened to the correct specifications.

2. Locate the ignition switch: The ignition switch is typically located on the left side of the handlebars. It is a small, rectangular box with various wires connected to it.

3. Disconnect the wires: Carefully disconnect all the wires connected to the ignition switch. Be sure to note the position of each wire for easy reconnection later on.

4. Remove the ignition switch mounting bolts: Using a socket and wrench, remove the bolts that secure the ignition switch to the handlebars. There are usually two bolts holding the switch in place.

5. Slide the ignition switch out: Once the bolts are removed, gently slide the ignition switch out of its mounting position. Be cautious as the switch may be attached to other components, such as the kill switch or turn signals.

6. Inspect the switch: Before installing a new ignition switch, it is essential to inspect the area where the old switch was mounted. Check for any damage or corrosion that may need to be addressed before installing the new switch.

7. Install the new ignition switch: Place the new ignition switch into the mounting position and secure it with the bolts removed earlier. Ensure that the switch is properly aligned and that all wires are connected correctly.

8. Tighten the bolts: Using a torque wrench, tighten the bolts to the manufacturer’s specifications. This will ensure that the new ignition switch is securely mounted.

9. Reconnect the wires: Reconnect all the wires to the new ignition switch, making sure that each wire is in its correct position. Double-check to ensure that all connections are secure.

10. Test the ignition switch: Turn on the motorcycle and test the new ignition switch to ensure that it is functioning correctly. Check for any issues, such as the kill switch not working or the turn signals not activating.

By following these steps, you should be able to successfully remove the ignition switch from your 1970 Honda CL175. Remember to take your time and be patient throughout the process. With a little practice, you will be able to perform this task with ease and confidence. Happy riding!