How to Successfully Install Your Larson Storm Door Handle- A Step-by-Step Guide

How to Install Larson Storm Door Handle

Installing a Larson Storm Door Handle is a task that can be completed by most homeowners with a few basic tools and a bit of patience. The Larson Storm Door Handle is designed to provide both security and ease of use, making it an essential component of your storm door. In this article, we will guide you through the process of installing a Larson Storm Door Handle, ensuring that your door operates smoothly and securely.

Before You Begin

Before you start the installation process, gather the following tools and materials:

– A screwdriver
– A hammer
– A drill and drill bits (if necessary)
– Replacement handle (if needed)
– New screws (if needed)

Ensure that you have the correct replacement handle for your Larson Storm Door. If you are unsure, consult the manufacturer’s specifications or bring your old handle to a hardware store for assistance.

Step 1: Remove the Old Handle

1. Begin by locating the screws that secure the old handle to the door. These screws are typically located on the side of the handle, but may vary depending on the model.
2. Using a screwdriver, carefully remove the screws and set them aside.
3. Gently pull the old handle away from the door, ensuring that it does not become damaged in the process.

Step 2: Install the New Handle

1. Take the new Larson Storm Door Handle and position it over the hole where the old handle was removed.
2. Insert the new screws through the holes in the handle and into the door. Tighten the screws securely, but be careful not to overtighten, as this may damage the door or the handle.
3. If necessary, use a hammer to gently tap the handle into place, ensuring that it is seated properly.

Step 3: Test the Handle

1. Once the new handle is installed, test it by opening and closing the door a few times. Ensure that the handle operates smoothly and that there are no loose parts.
2. If the handle feels loose or if it does not operate properly, double-check the screws to ensure that they are tight and that the handle is properly seated.

Step 4: Final Touches

1. After you have confirmed that the handle operates smoothly, take a moment to inspect the installation. Make sure that there are no gaps between the handle and the door, as this may allow air to leak through.
2. If necessary, adjust the handle by slightly loosening the screws and moving the handle into the correct position.

Congratulations! You have successfully installed a Larson Storm Door Handle. With this new handle, your storm door should provide enhanced security and ease of use. If you encounter any issues during the installation process, consult the manufacturer’s instructions or seek assistance from a professional.