How to Install Flush Lever on Toilet
Installing a flush lever on a toilet is a relatively simple task that can greatly enhance the functionality and convenience of your bathroom. Whether you are replacing an old flush lever or installing one on a new toilet, this guide will walk you through the process step by step.
Materials Needed:
Before you begin, gather the following materials:
– New flush lever
– Replacement parts (if necessary)
– Adjustable wrench
– Screwdriver
– plumber’s grease
– rag or towel
Step 1: Turn Off the Water Supply
Before you start working on the toilet, it’s essential to turn off the water supply to avoid any leaks or water damage. Locate the shut-off valve, which is typically located behind the toilet. Use the adjustable wrench to turn the valve clockwise until it is completely closed.
Step 2: Remove the Old Flush Lever
Locate the old flush lever on the top of the tank. It is usually held in place by a few screws. Use a screwdriver to remove the screws and gently pull the lever off the tank.
Step 3: Check for Replacement Parts
Inspect the old flush lever for any signs of wear or damage. If you notice any issues, such as a broken chain or a loose handle, you may need to replace these parts before installing the new flush lever.
Step 4: Install the New Flush Lever
Take the new flush lever and position it on the tank. Make sure it is aligned correctly and fits securely. If the lever comes with screws, use a screwdriver to attach it to the tank. If not, you may need to use plumber’s grease to lubricate the threads and ensure a tight fit.
Step 5: Attach the Chain
Connect the chain to the new flush lever and the lift arm inside the tank. Adjust the chain length so that the lever can lift the lift arm without causing it to bind or hang up.
Step 6: Test the Flush Lever
Turn the water supply back on and test the flush lever. Press the lever down to flush the toilet and observe the performance. If the lever operates smoothly and the toilet flushes properly, you have successfully installed the flush lever.
Step 7: Clean Up
Once you are satisfied with the installation, clean up any spills or debris from the work area. Dispose of the old flush lever and any replacement parts properly.
Installing a flush lever on a toilet is a straightforward process that can be completed in just a few steps. By following this guide, you can ensure a successful installation and enjoy the convenience of a functional flush lever in your bathroom.
